Become a member of the iLounge Forums. Register Now!
To start viewing messages, select the forum that you want to visit from the selection below.
If this is your first visit, be sure to check out the Forum FAQ and Forum Policy.
If this is your first visit, be sure to check out the Forum FAQ and Forum Policy.
Topic: 2002 Trailblazer / GMC Envoy Owners
|
|
#1
|
||
|
Freshman Lounger
Join Date: Dec 2004
Posts: 4
|
Just a note to those who have the Class II RDS w/Bose and 6-disc in-dash radios (model #15058231): Apparently, no one make an AUX-IN kit that works correctly with this particular unit. I talked to an engineer at PAC-AUDIO and at USA-SPEC, they both said the radio has the aux disabled because it uses it for the built in 6-disc.
But there is a work around: The head unit sends its audio to the amps at a constant level, and the amp's volume is digitally controller via the Databus. So you can do this: Wire up a relay switch to toggle between your own input and the radio's output. 24-pin connector: A9 - Left (-) dk green A8 - Left (+) tan B10 - Right (-) org / blk B11 - Right (+) lt green You MUST use a ground loop isolator and 2 DPDT relays so that you are completely disconnecting all 4 wires from the head unit and connecting them to your own input. Radio Left (-) ----------/------- Amp Left (-) Radio Left (+) ----------|/------ Amp Left (+) Radio Right (-) ---------||/----- Amp Right (-) Radio Right (+) ---------|||/---- Amp Right (+) In L (-) --------|************| --- To Amp L (-) In L (+) --------|GND Isolator| --- To Amp L (+) In R (-) --------|************| --- To Amp R (-) In R (+) --------|************| --- To Amp R (+) I tried it out and it works great! It's a little tight to splice the factory harness, but it does the trick. -hj |
||
|
|
|
Join the iLounge Community and the ad above will disappear.
Topic: 2002 Trailblazer / GMC Envoy Owners
Become a member of the iLounge Forums. Register Now!
To start viewing messages, select the forum that you want to visit from the selection below.
If this is your first visit, be sure to check out the Forum FAQ and Forum Policy.
If this is your first visit, be sure to check out the Forum FAQ and Forum Policy.
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
View iLounge History. Read our old Forums Archive (2001-2003)
All times are GMT -4. The time now is 05:30 PM.
All times are GMT -4. The time now is 05:30 PM.











Linear Mode



