Otterbox Defender Case

[Raphun]

I have just gotten one. I liked the looks of it from the review and website, but I have an issue that I hope someone can help me solve so I don't have to return it. I can't seem to get the bubbles to go away from under the screen protector. I've tried wiping my hand over the iphone like the instructional video on the website suggested, but that didn't work. Does anyone out there that owns an otterbox have any suggestions?

Thanks

Raphun

[dogratty]

i had same problem, griped to otterbox, they told me to not clean it before putting it in, wiping my hand over etc etc,
but before i had the chance to do so, it cleared up and hasnt happened again.
probably electrostatic charge that has to dissipate, but after week one - no problem with sticky screen

[Chunk]

How sturdy is the belt clip on the Defender?

[digishank]

Hi Raphun,

Normally your problem occurs when the cover is open to water pixels in the air, before you put it on the iphone. Where did u buy it.In my case i bought mine from press digital and it came with completly sealed. So didn't got in to trouble.

By the way, only way to remove that bubble is to take off the cover and remove all the water pixels from the case.May be by turning it to on to some air from a fan.But make sure it contains no dust.

Thanks,
Shank

[kygol]

I recently got a defender for the 3g and the belt clip already broke from removing the iphone a few times a day. it was replaced immediatly, but I am not a fan of the overall case for the $50! Would not buy again. The belt clip also is unstable when it comes to holding the iphone in the clip, unless the iphone faces inward. When this is done, it is difficult to remove (or use touchscreen without removing!) which causes stress and thus cracks the clip/holster!