invisible shield + water = AHH!

[secretagent437]

Ok....so i bought an invisible shield. I have applied it once to my iPod and it was getting a little scratched and majorly dirty. So i get the new one and i apply it. Everything goes fine but i think i used too much water. Now my click wheel isn't working and it has been 2 days. I don't know what to do. Please help. Thanks.

-Joe

[secretagent437]

i already tried resetting it and it didn't work

[VBRJunky]

You're probably out of luck since you cannot turn your player off. If you can, let it dry before you turn it back on. Or else you are doing more damage.

[catalyst_exoh]

my friend left her ipod out in the rain,BY ACCIDENT!!! and she brought it inside, and just let it sit somewhere warm and dry for a week or so, and then it worked fine. lol

[gravis86]

Contact InvisibleShield. They will replace your iPod.

[secretagent437]

i recently tried the Menu and Center button reset and it worked...so maybe that's a good sign. Hopefully...

[k101]

wat i did is put all the IS on except 4 the click wheel

[FridayRain]

I hope InvisibleShield DOESN'T replace it. They advise you to use their solution, not water. It's safe to assume that their solution is not conducive. It's your fault.

But, fortunately, modern electronics tend to work once the water dries. I've witness countless cell phones being dropped in beer and water and working once they dry. Someone even used a blow dryer to hasten the process.

I'm still shocked that your iPod was scratched post-InvisibleShield. This may be the only reason they'll consider replacing it.

And there's no reason not to put all of it on.

[Sithtradmus]

My friend sunk his ipod 5 times in water, the whole thing *He tried 2 break it*, and after 3 days, it worked fine, I'd suggest putting it under ur bed or in the sunlight for a few days, it'll work fine, just let it air out...